7.
Turn the bookcase on one side and hook one end panel (Ref.
No. 3) over the front of the upright. Then slip the end panel
around the back of the unit and over the Tinnerman clips
(some force may be required to do this). Secure the end panel
to the back by tightening two sheet metal screws (Ref. No. 10)
into the Tinnerman clips. When this is completed, turn the unit
onto the opposite side and
repeat this procedure.
8.
At the front of the top of each
upright, place a Tinnerman clip
over the slotted hole as shown.
9.
Set the unit upright and place the top shelf (Ref. No. 5)
into position. The edges of the shelf will fit on the outside
of the two uprights and the back. The Tennsco logo
should face the front of the bookcase.
10.
Bolt the back to the top using
three 10-24 x 1/2 bolts
and nuts. Then bolt the rear
corners at the back to the
top using sheet metal screws
in Tinnerman clips already
inserted.
11.
Bolt the front of the top to
each upright using two
Tinnerman clips (which were
inserted in step 9) and two
sheet metal screws. These
holes are hidden underneath
the front lip of the bookcase
top.
12.
If necessary, move the shelf which had been inserted in
step 6 for stability, to a more suitable position.
13.
Place the two dividers (Ref. No. 8) as desired. Your B-3000
bookcase is now ready for use.
