OPERATION
22
Tennant T5e (10--06)
To Adjust a Tapered Brush Pattern:
Tools required: 10mm wrench and 6mm hex wrench
1. Raise the scrub head off floor and remove key.
2. Remove the idler plate from the brush (Figure 55).
FIG. 55
3. Hold the brush plug shaft with a wrench and loosen
the 6mm hex screw (Figure 56).
FIG. 56
4. To lower the brush end, turn the shaft clockwise for
the front brush and counter--clockwise for the rear
brush. Retighten hex screw (Figure 57).
FIG. 57
5. Recheck brush pattern.
NOTE:
Replace brushes when bristles are worn to 15
mm.
MACHINE MAINTENANCE
To keep the machine in good working condition, it’s
important that the following maintenance procedures
are performed on a routine basis.
WARNING: Electrical Hazard. Disconnect
Battery Cables Before Servicing Machine.
DAILY MAINTENANCE (After Every Use)
1. Drain the recovery tank (Figure 58).
FIG. 58
2.
Rinse out the recovery tank (Figure 59).
FIG. 59
3. Remove the recovery tank float shut--off screen
and clean (Figure 60).
FIG. 60