Tennant R3 ReadySpace, Operator'S Manual

Page: 9 / 69

OPERATION
EN
9
Tennant R3 (03--08)
6. The roller motor circuit breaker may trip if the
rollers are set too low or if the rollers are
obstructed. To reset the circuit breaker, unplug the
power cord, determine cause and reset the 5 amp
circuit breaker button (Figure 16).
FOR SAFETY: Before removing an obstruction
from the rollers unplug power cord from wall
outlet.
FOR SAFETY: When operating machine, if foam or
liquid begins to leak from machine, immediately
shut off machine.
FIG. 16
7. View the water pickup from the recovery window
(Figure 17). When the water pickup stops, unplug
the power cord and empty the recovery tank.
The machine is equipped with a vacuum shut--off
float that will automatically stop the water pickup
when the recovery tank reaches the full point. A
sudden change in vacuum motor sound will occur.
FIG. 17
ATTENTION: Check for excessive foam in the
recovery tank. Empty tank if excessive. Foam may
not activate the shut--off float which may result in
vacuum motor damage.
8. When transporting machine, roll the machine on
both the main and rear tilt wheels.
FOR SAFETY: When transporting machine, do not
wheel up or down stairs.
CLEANING WITH ACCESSORY TOOLS (Option)
1. Connect the accessory tool hoses to solution hose
coupler and vacuum hose port located at the front
of the machine (Figure 18).
FIG. 18
2. Fill the solution tank (See FILLING SOLUTION
TANK on page 6).
3. Press the main power switch to the on ( I ) position
(Figure 19).
FIG. 19