IB 340463 (1-01)
1
No. 340463
Machine: Litter Hawk
t
t
t
t
Published: 1-01/00
System: OPTIONS
INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the Parts
List in the appropriate place in your machine manual for future reference.
Retaining the Parts List will make it easier to reorder individual parts and will
save you the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit numbers 382589, 382590, 382597, 382598, 382599 and 382600
SYNOPSIS / PROBLEM:
This kit contains the parts needed to install a new colored hood assembly on the model
Litter Hawk
t
litter vacuum.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 1 hour)
PREPARATION:
(Refer to FIG. 1 and 2)
FOR SAFETY: Before leaving or servicing machine, stop on level surface and set parking
brake. Then turn off machine and remove key.
1. Opent the rear machine cover/ seat , and disconnect the battery cables from the machine.
2. Open the front cover assembly, and secure intop position with the cover support rod.
WARNING: Always disconnect battery cables from machine before working
on electrical components.
INSTALLATION:
(Refer to FIG. 1 and 2)
1. Locate the front strobe harness under the front cover. Disconnect the front strobe harness
from the main harness.
(Refer to FIG. 1)
2. Disconnect, and remove the cover support rod and mounting bracket from the machine.
3. Lift and remove the front cover assembly from the mounting bracket.
(Refer to FIG. 1)
4. Mount the new strobe assembly to the new front cover (1) with the prop rod plate (16),
washers (5, 22) and lock nuts (7, 23). Hand tighten the mounting hardware.
(Refer to FIG. 2)
5. Secure mounting plate 382766 to studs on top of the support plate.
(Refer to FIG. 2)
6. Mount the LH latch arm to the prop rod plate (16) with a washer (20) and cotter pin (21).
(Refer to FIG. 2)
7. Mount the RH latch arm to the LH latch arm with the coil spring (14), washer (22) and lock
nut (23).
(Refer to FIG. 2)
