MAINTENANCE
215E MM158 (11--91)
3-28
BRUSHES
MAIN BRUSH
The main brush is tubular and spans the width of
the machine, sweeping debris into the debris
hopper. It should be inspected daily for wear or
damage. Remove any string or wire found tangled
on the main brush, main brush drive hub, or main
brush idler hub.
Rotate the main brush end-for-end after every 50
hours of operation for maximum brush life and
best sweeping performance.
The main brush pattern should be checked daily.
It should be 2 to 2.5 in (50 to 65 mm) wide with
the main brush in the (Main Brush Down) position.
Main brush pattern adjustments are made by
turning the height adjustment knob on the
instrument panel.
The main brush should be replaced when the
remaining bristles measure 1.25 in (30 mm) or
less in length.
TO REMOVE MAIN BRUSH
1. Stop motor and set the machine parking
brake.
FOR SAFETY: Before Leaving Or
Servicing Machine; Stop On Level
Surface, Set Parking Brake, And Turn
Off Machine.
2. Place the main brush position lever in the
(Main Brush Down) position.
3. Open the left side access door.
4. Remove the brush idler arm retaining bolts
from the arm hub.
A
B
C
01128
REMOVING MAIN BRUSH IDLER ARM
A. Brush Idler Arm
B. Arm Retaining Bolt
C. Access Door
5. Pull the brush idler arm off the arm hub.
6. Grasp the main brush, pull it off the brush
drive plug, and out of the main brush
compartment.
TO INSTALL MAIN BRUSH
1. Place main brush on the floor next to the
access door.
2. Align the main brush drive slots with the
drive keys on the main brush drive plug.
3. Slide the main brush into the brush
compartment and onto the drive plug. Make
sure the drive slots and keys mate.
B
A
01129
INSTALLING MAIN BRUSH
A. Main Brush
B. Idler Arm
4. Align the main brush idler plug slots with the
main brush keys.
5. Slide the main brush idler plug into the main
brush tube.
6. Slide the brush idler arm onto the arm hub.
7. Thread the brush idler arm retaining bolts
through the idler arm and into the arm hub.
8. Tighten the brush idler arm retaining bolts.
Summary of Contents for 215E
