Tenma 72-7930, Operating Manual

Page: 6 / 36

Warning
To avoid possible electric shock or personal injury,
and to avoid possible damage to the Meter or to the
equipment under test, adhere to the following rules:
l
Before using the Meter inspect the case. Do not
use the Meter if it is damaged or the case (or part
of the case) is removed. Look for cracks or missing
plastic. Pay attention to the insulation around the
connectors.
l
Inspect the test leads for damaged insulation or
exposed metal. Check the test leads for continuity.
Replace damaged test leads with identical model
number or electrical specifications before using
the Meter.
l
Do not apply more than the rated voltage, as
marked on the Meter, between the terminals or
between any terminal and ground.
l
The rotary switch should be placed in desired
position prior to connecting leads. This position
should not be changed while leads are connected.
l
When using the Meter at an effective voltage
over 60V DC or 30V rms AC, special care
should be taken for there is danger of electric
shock.
l
Use the proper terminals, function, and range
for your measurements.
l
If the value to be measured is unknown, use the
maximum measurement position and reduce the
range step by step until a satisfactory reading is
obtained.
l
Do not use or store the Meter in an environment
of high temperature, humidity, explosive, inflammable
and strong magnetic field. The performance of
the Meter may deteriorate after dampened.
Safe Operation (1)
Model 72-7930: OPERATING MANUAL
6