The frequency value within the selected range is adjusted by the use of the vernier knob
located below the display. This is a continuously adjustable knob
that allows the adjustment of the frequency anywhere within the
selected range.
Waveform Shape:
The waveform shape is select
ree buttons allows you to select
modify
he OFFSET function allows the user to adjust where the
h
w
e output wave to be non-symmetric.
mplitude Control and Output:
he AMPLITUDE vernier adjusts the
n
This is where you will connect to the unit to obta
weep Mode:
addition to the basic signal, this unit has the ability to “sweep” the base frequency
this.
ns
hen
ed by three buttons located at the bottom of the face.
Pressing one of these th
either a sine wave, triangle wave or square wave.
In addition to the basic wave shape, it is possible to
the waveform by using one or more of the two OFFSET
and SYMMETRY functions.
T
zero crossing point of the repetitive waveform is. This can
be adjusted either positive or negative. (note that this
control and the amplitude control will interact with eac
other.) Leaving the button below the control out will
disable this function.
ill allow you to cause th
The SYMMETRY function
As an example the triangle wave can be skewed to be a sawtooth in either direction, or
anyplace in between the two extremes. Leaving the button below the control out disables
this function.
A
T
peak to peak value of the output signal
within the limits. Selecting the -20dB
button will lower the output range
allowing lower peak to peak values.
The OUTPUT connector is the locatio
that the signal is actually generated on.
in your useable signal.
S
In
through some range. The SWEEP
controls are the portion that controls
Under normal operation the two butto
are left out, disabling this function. W
pressed, the ON button starts the sweep
