3
OPERATION
•
Before using the soldering iron for the first time, wet the cleaning sponge and
place it in the iron holder tray. Keep it damp during use.
WARNING:
switch off the mains power before connecting or disconnecting the iron or
the control station may be damaged.
•
Connect the soldering iron to the control station by inserting the connector and
tightening the locking ring finger tight.
•
Place the iron in the holder and turn on the mains power.
Setting the temperature:
•
The digital display will initially
display the current set
temperature (the value from the
last usage) for three seconds.
•
After a few seconds it will display the actual temperature in °C or °F.
•
Pressing and holding the “up” or “down” button, you can quickly either increase or
decrease the temperature.
•
The display screen shows the set
temperature value followed by
the actual tip temperature.
Temperature unit exchange:
•
In the power-off condition, press and hold the “#” button, then turn on the station.
The temperature unit will change between “°C” and “°F” and will store the setting
automatically.
Storing and recalling 3 preset temperatures:
•
The three preset buttons can be used to store quick
access temperatures for instant recall.
•
Press and hold the “#” key followed by buttons 1, 2 or 3,
you can store the current temperature into memory.
•
Press buttons 1, 2 or 3 once to use the set temperature
stored as displayed at the bottom of the LCD screen.
Display of status:
SET: Set temperature
REAL: Real temperature
CAL: Calibration temperature
Setting value and temperature display
Temperature unit
Heater ON indicator
Memory temperature 3
Memory temperature 2
Memory temperature 1
