Tendercare Ltd
The Snugseat Spring User Manual
Document No 034-01v4 Snugseat Spring
User Manual.doc
Authority.
Quality Controller
Authorised.
J Adams
Page 11
Dec 05
4.5 Fitting pommel to seat
The pommel is mounted on an adjustable steel frame so that the height and depth can be
adjusted using thumbscrews. (See picture below).
To fit the pommel, pass the chrome bar with a slot in it through the slit in the front of the seat
cover. Then looking under the front of the seat, remove the thumbscrew shown in the picture
opposite. Insert the slotted bar of the pommel into the mounting slot then insert and tighten
the thumbscrew.
(See picture above).
NOTE: -
The seat cover is not shown for clarity.
To adjust the depth, loosen the thumbscrew under the seat and move the pommel in or out
until it is in the desired position then retighten the screw.
To adjust height, loosen the thumbscrew on the front of the pommel support tube. Move the
pommel to the desired height then retighten the screw making sure that the screw fits into one
of the indentations in the pommel support bar.
4.6 Tilt-in-Space
The angle of the seat and backrest (Tilt in Space) can be infinitely adjusted throughout its
range. Adjust the seat angle as follows: -
On the Nursery and Junior sizes there is a single gas spring. The gas
spring release lever, a small chrome lever, is located at the rear of
the seat. To operate place one hand in the middle at the front of the
seat just above the footrest location, and with the other hand gently
press the gas spring release lever backwards
(see picture opposite)
.
Allow the seat to recline slowly, when the required position is
reached release the lever to lock the seat in position.
Pommel attachment thumbscrew
Height adjustment thumbscrew