With the remote control, you can easily operate the following functions:
Before you can use the bed the handset must be paired to the control unit on the bed. This
only needs to be performed once.
1.
Remove the battery cover on the handset and insert the batteries, making sure they
are inserted the correct way. Do not replace the battery cover yet.
2.
Plug the mains plug into a socket and switch on, wait for the light on the control box
to go out.
3.
Press the pairing button (a) on the control box twice, this button will illuminate.
4.
Within 10 seconds off the LED illuminating press and hold the pairing button inside the battery
compartment of the handset (P), you will need a paper clip or tip of a pen to reach this button. The
pairing button on the control box will flash blue, when it stops flashing the pairing is complete.
5.
Replace the battery cover.
PLEASE NOTE: Only commission one system at a time. Never attempt to configure multiple systems
simultaneously. Do not touch the buttons of the handset while the unit is being commissioned.
1.
Set the required massage strength.
2.
Start one of the three different wave massage programmes.
3.
Set the intensity of the wave massage programmes.
4.
Operate the bed adjustment motor.
5.
Switch on and off the infra red receiver’s night light.
6.
Switch on and off the torch LED of the remote control.
INITIAL SET UP
BUTTON
FUNCTION
1
Memory Position 1
2
Memory Position 2
3
Memory Position 3
4
Save Memory Position
5
Back Adjustment Up
8
Back Adjustment Down
9
Foot Adjustment Up
12
Foot Adjustment Down
13
Back and Foot Adjustment Up
16
Back and Foot Adjustment Down
17
Massage Mode 1
20
Massage Mode 2
21
Massage Mode 3
24
Massage Off
25
Torch On/Off
26
Floor Lighting On/Off
27
Battery Indicator
28
No function
29
No function
32
Child Lock Mechanism On/Off
