TEMPUR
®
ERGO System
™
Pairing Instructions For Joining Two Bases
FOR 2 BASES TO OPERATE WITH 1 CONTROL
Assembling Split Dual Ergo Bases (Base A and Base B) to
be used together as a single King or CA King system.
NOTE: the use of “Base A” and “Base B” is for
description purposes only and the beds will not
actually be labeled “Base A” or “Base B”
STEP 1
Cut the straps on the boxes of Base A and Base B.
STEP 2
Carefully remove the box covers on Base A and Base B.
STEP 3
Before the bases are removed from their boxes, cut
the plastic strapping on each wired remote control
and remove the control from the base frame.
STEP 4
Carefully unplug the control from Base A and Base B.
STEP 5
Remove the hardwired remote controls and set aside.
Place the spare remote control in a safe place for any
future use.
STEP 6
Remove and extend one of the provided Y-cables
from the base frame.
STEP 7
Plug in the “A” output of the Y-Cable into Base A
control port.
STEP 8
Plug in the “B” output of the Y-Cable into Base B
control port.
STEP 9
Plug one of the provided hardwired remote controls
into the “Control Input” side of the Y-Cable.
STEP 10
Route the control cable to your preferred side of the bed.
Emergency Power Down Cycle Instructions
In the event that your TEMPUR
®
ERGO System™ Base looses power, there is an Emergency Power Down function.
NOTE: This functions is only if there is no power at the Control Box.
STEP 1
Place two (2) new alkaline 9-volt batteries into the Control Box.
STEP 2
Press the “FLAT” Button on the wired remote control until the base fully lowers to the flat position.
NOTE: Lowering the Ergo System Base using this method is slower than the standard process.
16
Customer Service: 1–800–979–1457
