15
syncing two bases
A Sync Cord is included with Twin Long and Split Cal King size bases.
The Sync Cord connects the two control boxes for the synchronization of two bases.
These steps are required in order to operate side-by-side Sleeptracker installations.
Disconnect the battery backup box cable from each Sleeptracker
®
Smart
Cable (make note where the cable was plugged in).
Remove
Sleeptracker
®
Sensor
cable from Sleeptracker
®
Processor on
Base A and plug into open port on Sleeptracker
®
Processor on Base B.
Make sure to properly route wires through rubber conduits. Disconnect
the Sleeptracker
®
Processor on Base A by unplugging it from the USB
Extension Cable.
If bases become mismatched, return both bases to the flat position to
re-sync the bases.
Connect the male end of each sync cord to the Sleeptracker
®
Smart Cable.
Insert it into the same port that you disconnected the battery backup box
from in Step 2.
Plug bases back into the power source.
Check to ensure all cords are securely attached. Both remotes will now
operate both bases simultaneously.
For both bases to operate independentely with their remote controls
instead of simultaneously, please use the Tempur-Pedic
®
Sleeptracker
®
app
to setup the bases as 'split'. This is generally preferred when using split
mattresses.
Unplug the base(s) from power source.
Connect each battery backup box male connection to the sync cord
female connection (Refer to illustration at right).
STEP 3
STEP 6
STEP 7
STEP 8
STEP 2
STEP 5
STEP 1
STEP 4
PERFORMANCE NOTES
Battery
Backup
Box 1
Sync Cord
Sleeptracker
®
Smart Cable 1
Sleeptracker
®
Smart Cable 2
Battery
Backup
Box 2
Control Box 1
Sleeptracker
®
Processor
(A)
Sleeptracker
®
Processor
(B)
Sleeptracker
®
Sensor cable
Control Box 2
The system is now linked. Pressed buttons on either remote will
control the two bases simultaneously.
Return to page 8 step 4 for additional setup information.
B A
A
B
