ENGLISH INSTRUCTION MANUAL
4
LEVELING
If the refrigerator is not leveled during installation .The doors may not close or seal properly, which
causing cooling, frost or moisture problems. It is very important for the refrigerator to be leveled in
order to function properly
To level your refrigerator you may either turn the level leg clockwise to raise that side of the
refrigerator or turn counter
-
clockwise to lower that side.
USE OF THE APPLIANCE
Your unit has only one control for regulating the temperature in the compartment. The temperature
control is located on the upper right hand side of the compartment.
The first time you turn the unit on, set the temperature control to “6”.
The range of the temperature control is from position "OFF” to “6”. After 24 to 48 hours, adjust the
temperature control to the setting that best suits your needs. The setting of “3” should be
appropriate for home or office use.
To turn the appliance off, turn the temperature control to”OFF”.
NOTE:
Turning the temperature control to “OFF” position stops the cooling cycle but does not shut off the
power to the unit.
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the unit will not start.
Replacing the LAMP
1 Remove the plug, cutting off the power supply.
2 According to figure 1 instruction, remove the lamp cover.
3 According to figure 2 instruction, rotation can remove the light bulb, then turn the opposite way to
install the new light bulb.
4 Replace cover, connect power supply.
NOTE:
Do not use a bulb with a wattage greater than 15W.
PROLONGED OFF PERIODS
If the refrigerator is not used for a long period of time, proceed as follows:
Disconnect the refrigerator from the main supply by removing the plug from the wall socket
Clean and dry the inside as instructed under the heading Before Using Your Refrigerator
Leave the door open to prevent any unpleasant smells from building up while the refrigerator is not in
use.
