Safety and Warnings
Elevated Operating Ambient Temperature: If installed in a closed
envi‐
ronment, make sure the operating ambient temperature is compatible
with the maximum ambient temperature specified by the manufacturer.
Reduced Air Flow: Make sure the amount of air flow required for safe operation of
the equipment is not compromised during installation.
1. Connect a computer to the HIPswitch-75 using the micro USB console port located on the
back of the HIPswitch.
2. Using a terminal (macOS, Linux) or terminal emulator (Windows), connect to the HIPswitch
using baud 115200.
3. At the login prompt, enter
hipsh,
then
hipsh
as the password.
4. At the hipsh prompt, enter
conductor set https://<conductor address>:<port>
6. At the hipsh prompt, enter
reboot
After rebooting, the HIPswitch should now be recognized in the Conductor UI.
Provisioning the HIPswitch-75
The Conductor is the central configuration and managementpoint for all HIPservices. For
provisioning, a HIPswitch must be able to locate the Conductor on your shared network. The
fastest method is to connect the HIPswitch via the console port.
Regulatory Information
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions: (1) This device may not cause interference; and (2) This device must
accept any interference, including interference that may cause undesired operation of the de‐
vice.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: 1) l’appareil ne
doit pas produire de brouillage; 2) l’utilisateur de l’appareil doit accepter tout brouillage ra‐
dioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonction‐
nement."
Radiation Exposure
: This equipment complies with FCC and ISED radiation exposure limits
set forth for an uncontrolled environment. This equipment should be installed and operated
with minimum distance of 20cm between the radiator and your body and must not be co-lo‐
cated or operating in conjunction with any other antenna or transmitter.
Déclaration sur l'exposition aux rayonnements RF:
L'autre utilisé pour l'émetteur doit être
installé pour fournir une distance de séparation d'au moins 20 cm de toutes les personnes et
ne doit pas être colocalisé ou fonctionner conjointement avec une autre antenne ou un autre
émetteur.
Tempered Networks, Inc declares that the HIPswitch-75w is in compliance with
Directive
2014/53/EU. This device may be used in all EU member states subject to
the following condition: This device may only be used indoors.
The full text of the EU declaration of conformity is available at the following
I
nternet
address: https://repo.tempered.io/DoC/75w
