8
2H TIMER MODE
The “2h Timer” mode can be used to quickly heat the room or speed up the drying of towels.
•
Press the [Prog] key until the “2H” icon appears on the screen
The appliance is switched on at maximum power for 2 hours, but the ambient temperature, for safety
reasons, cannot be higher than 30° C. The “2h Timer” mode stops automatically after a period of 2
hours and returns to the previously set operating mode. If necessary, the user can return to other
modes at any time simply by pressing the [Prog] key.
CHRONO MODE
Chrono mode programming
a) Set the current day and time
•
Activate the “Standby” mode and press the [Chrono] key for more than 3 seconds.
•
The display will show the words: “Ted.”
•
Press the [Prog] key to enter the mode. Set the current day with the [+] and [-] keys (1 to 7).
•
Press the [Prog] button again to confirm.
The display now shows the current time to be confirmed.
‘Hours’: use the [+] and [-] keys to set the hour and confirm with the [Prog] key.
‘Minutes’: repeat the same procedure and confirm with the [Prog] key.
•
At the end, the thermostat returns to “Standby” mode.
b) Set the program for Chrono mode (P4)
•
Enter the “Standby” mode and press the [Chrono] key for more than
3 seconds.
•
At the top of the screen, you will see the words: “Ted.”
•
To configure the “Chrono” mode time sequence, press the [+] key until
the word ‘’ Prog ‘’ (Programming) appears on the screen. [See the
photo on the right].
•
Press the [Prog] key to enter the mode.
Now you can set a time sequence for each day of the week.
From day 1, select the desired sequence with the [+] and [-] keys to select, for each hour, between
the “Comfort” temperature button (full bar) [+] and the “Night” temperature key. (empty bar) [-].
Press [Prog] to confirm the setting for the first day, repeat the same procedure for the remaining 6
days of the week.
c) To use a preset mode (P1 P2 P3) or programmable mode (P4)
Press the [Stand-By / ON] key and exit standby mode, press the [Prog] key
until the symbol appears on the screen.
At the top of the screen, the program in use is shown (from P1 to P4), the
programs are selected by pressing the [Chrono] Key, on the outside of the
screen you can see, for each program, the operation bars time of the indi-
cated program.
