Installation and Operating
Instructions for Gas Log
Heaters
Models: PS24RN, PS24RP
Models with “N” after the model number use natural gas; models with “P” after the model number use propane (LP) gas.
READ AND SAVE THESE INSTRUCTIONS
This appliance operates as an unvented room
heater certified under ANSI Z21.11.2-2000 when
fitted to a solid fuel burning masonry or factory
built fireplace with the flue damper closed. It also
operates as a decorative appliance under ANSI
Z21.60a-2000.CSA 2.26a-2000, when fitted to a solid
fuel burning masonry or factory built fireplace with
the flue damper open. When used as a decorative
appliance, the use of a thermostat is not allowed.
State or local codes may only allow operation of
this appliance in a vented configuration. Check
your state or local codes.
This is an unvented gas-fired heater. It uses air (oxygen) from the room in which it is installed. Provisions
for adequate combustion and ventilation air must be provided. Refer to Section Provisions For Adequate
Combustion and Ventilation Air - Page 4.
FOR YOUR SAFETY
—
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or
any other appliance.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier’s instruc-
tions.
•
If you cannot reach your gas supplier, call the fire department.
—
Installation and service must be performed by a qualified installer, service agency or the gas
supplier.
WARNING
If the information in this manual is not followed exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
76683 11/03 Rev. 14
5L24
410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7777
Temco Fireplace Products
Gas Fired
Unvented
Room Heaters
PATENT NO. US 6,390.808 B1
