Telycam TLC-700-IP-35-4K, User Manual

Page: 9 / 40

7
IR REMOTE CONTROLLER
POWER
Under normal working mode, short press POWER key, to enter standby mode;
Press it again, the camera will do self-configuration, then go back to HOME position.
It will go to preset position if power on model has been set before.
FREEZE （ Not Supported in USB ）
Short press FREEZE key to freeze/ unfreeze the image.
IRT (IR Transfer/IR Pass)
Open / close the IR pass function. Once press the IRT key, the camera will receive and
Pass the IR remote control signal to the codec/terminal (via VISCA IN port).
SET 1~SET4 ADDRESS SETTING
Long press for 3seconds until the key light ON, to set camera address.
CAM1~CAM4 （ CAMERA SELECTING ）
Short press to select the relative camera.
NUMBER KEY (1-9)
Set preset: long press (3 seconds) the number key to set preset.
Run preset: Short press the number key to run preset.
CLR PRE (CLEAR PRESET)
CLR PRE+ number key: to clear the relative preset.
Long press to clear all preset.