USING THE ARCATA PHONE
28xx CIP-D User Guide
33
CALLBACK
There are several types of Callback described
here:
• station
• trunk
Note
See the
ACCESS CODES AND AUDIBLE TONES
chapter for a table of access codes for your
phone.
Station Callback
The Callback feature places an automatic
callback on an extension that is busy or does not
answer. When the party you called hangs up or
returns and uses his or her phone once, your
extension will ring. If you answer the callback, the
system dials the extension.
To set up a Station Callback:
1. When making a call, you hear the busy signal
or the call rings without being answered.
2. Dial the Callback Access Code (2) or press the
Callback feature button if configured by the
System Administrator. Hear the confirmation
tone.
3. Replace the handset.
4. Hear ringing.
5. Lift the handset and wait for answer.
To cancel a Station Callback:
1. Dial the extension with Callback set up and
then replace the handset.
Summary of Contents for Arcata 2806 CIP-D
