Teltonika TFT100, Quick Manual

Page: 6 / 13

6
TFT100 | Wiki
How to install USB drivers
(Windows)
1. Please download COM port drivers from here .
2. Extract and run TeltonikaCOMDriver.exe .
3. Click Next in driver installation window.
4. In the following window click Install button.
Setup will continue installing the driver and eventually the
confirmation window will appear. Click
Finish to complete the setup.
PC Connection (Windows)
1. Power-up TFT100 with DC voltage (10 – 97 V) power supply using
power cable . LED’s should start blinking, see “ LED indications ”.
2. Connect device to computer using Micro-USB cable or Bluetooth
connection:
• Using Micro-USB cable
▬
You will need to install USB drivers, see “ How to install USB
drivers (Windows) ”
• Using Bluetooth
▬
TFT100 Bluetooth is enabled by default. Turn on Bluetooth
on your PC, then select Add Bluetooth or other device >
Bluetooth . Choose your device named –
“ TFT100_last_7_imei_digits ”, without LE in the end. Enter
default password 5555 , press Connect and then select
Done .
3. You are now ready to use the device on your computer.
Configuration (Windows)
At first TFT100 device will have default factory settings set. These
settings should be changed according to the user's needs. Main
configuration can be performed via
Teltonika Configurator software.
Get the latest Configurator version from here . Configurator operates
on Microsoft Windows OS and uses prerequisite MS .NET Framework .
Make sure you have the correct version installed.
Table 2 MS .NET requirements
MS .NET requirements
Operating
system MS .NET Framework
version
Version Links
Windows Vista
Windows 7
Windows 8.1
Windows 10
MS .NET Framework
4.6.2
32 and 64 bit www.microsoft.com
Downloaded Configurator will be in compressed archive. Extract it
and launch Configurator.exe . After launch software language can be
changed by clicking in the right bottom corner (Figure 8 Language
selection).