Quick Manual v1.0 // FMM150
12
Telematics
MOUNTING RECOMMENDATIONS
CONNECTING WIRES
•
Wires should be fastened to the other wires or non-moving parts. Try to avoid heat emitting and moving objects near the
wires.
•
The connections should not be seen very clearly. If factory isolation was removed while connecting wires, it should be applied
again.
•
If the wires are placed in the exterior or in places where they can be damaged or exposed to heat, humidity, dirt, etc., additional
isolation should be applied.
•
Wires cannot be connected to the board computers or control units.
CONNECTING POWER SOURCE
•
Be sure that after the car computer falls asleep, power is still available on chosen wire. Depending on car, this may happen in
5 to 30 minutes period.
•
When module is connected, measure voltage again to make sure it did not decrease.
•
It is recommended to connect to the main power cable in the fuse box.
•
Use 3A, 125V external fuse.
CONNECTING IGNITION WIRE
•
Be sure to check if it is a real ignition wire i. e. power does not disappear after starting the engine.
•
Check if this is not an ACC wire (when key is in the first position, most of the vehicle electronics are available).
•
Check if power is still available when you turn off any of vehicles devices.
•
Ignition is connected to the ignition relay output. As alternative, any other relay, which has power output when ignition is on,
may be chosen.
CONNECTING GROUND WIRE
•
Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.
•
If the wire is fixed with the bolt, the loop must be connected to the end of the wire.
•
For better contact scrub paint from the spot where loop is going to be connected.
