33
6.2.2
Information area
FMB630 information area is divided into 2 parts located on the top right and bottom of the
configurator. When configurator is connected to the device via USB or COM2 port all necessary
information about the device is shown here:
IMEI – unique number for every FMB630 and usually servers recognize different
devices by this number;
Version – firmware version of the device;
Hardware version – hardware version of the device;
Bytes available – shows how much bytes remains in configugration.
SOURCE – configuration source (device or file);
STATUS – status bar;
SECURITY STATUS – status of the configurator security;
SIM PIN STATUS – status of SIM card in the device;
6.2.3
Profiles/global parameters selection area
FMB630 has 4 user editable profiles stored in Flash no. 1-4 memories and one extra profile
stored in Flash no. 0 which cannot be edited by user. Profile from Flash no. 0 is used by system
and cannot be selected as active, while profiles from Flash no. 1-4 are fully editable and can be
selected as active.
Reading profiles, Global parameters and External Devices from Flash memory is a very
simple procedure. By pressing “Load” button all 4 profiles, Global parameters and External
Devices are loaded to the configurator (Figure 23). To configure 3
rd
profile choose the TAB
named “Profile 3” and all configurable parameters of this profile will be available to change.
Figure 23 FMB630 Configurator profiles loading window
After changing profile, Global parameters and External Devices, changes can be saved to
FMB630 Flash. By pressing “Save” button all 4 profiles, Global parameters and External Devices
are saved to the Flash (Figure 24).
Figure 24 FMB630 Configurator profiles saving information
