41
Figure 32 FM55 Features->Trip Configuration
If I/O Odometer is enabled and Continuous distance counting variable is set to Continuous,
Trip distance is going to be counted continuously (from Trip start to Trip stop). This value is
written to I/O Odometer value field. When Trip is over and next Trip begins, Odometer value is
not reset to zero, it is counted continuously again.
If I/O Odometer is enabled and Continuous Distance Counting variable is set to Not, then
distance is going to be counted only between every record made. This value is written to I/O
Odometer value field and reset to zero every new record until Trip stops. If later all Odometer
values are summed up manually user gets distance driven over the whole Trip period.
6.3.1.3.4
Geofencing
6.3.1.3.4.1
Geofencing settings
FM5500 has 20 configurable Geofence zones and it can generate event when defined
Geofence zone border has been crossed.
Figure 33 FM55 Features->Geofencing Configuration (1)
