Help
12
If the Telstra T110 will not operate
Check the telephone installation. See page 5.
Check that the Ringer Switch is set ON.
Unplug the Telstra T110 and connect a telephone that is known to be
working.
Important safety instructions
Read and understand all instructions.
Follow all warnings and instructions marked on this product.
Do not use this product during an electrical storm, as it is possible to get a
shock.
Do not use this product when near water, or when wet.
Make sure the line cords are protected from damage.
Keep the product away from heaters and away from sunlight.
Do not use this telephone near flammable gases or liquids.
Slots and openings in the cabinet are provided for ventilation, to protect it
from overheating. Ensure these are not blocked or covered.
Do not open the unit. There are no user serviceable parts inside. Warranty
conditions will not apply if the unit has been opened.
Unplug this unit before cleaning. Do not use detergents or sprays. To
clean the outside plastic parts, use only a damp cloth.
Do not push objects into ventilation openings. This could cause an
electrical shock.
General information
This Unit complies with Australian Communications Authority Technical
Standards.
If the quantity of ringing devices connected to the telephone line exceeds
a REN of 3, it may result in some devices not ringing in response to an
incoming call. To check the REN of each device, refer to the base label.
Using your Telstra T110
11
If any error occurs in the
storing mode you will hear
three short beeps, then the
product will return to talk
mode. If you unplug your
T110 the numbers stored in
the memory will be saved.
However, the last number
redial memory will be lost.
To dial a number in the memory
1. Lift the handset and wait for the dial tone.
2. Press the
button.
3. Press the memory location number
between
0
and
9
, under which the number
is stored.
The number is dialled automatically.
To delete stored numbers
1. Lift the handset.
2. Press the
button. The call indicator
light will flash.
3. Press the memory location number (
0-9
)
or
under which you have
stored the number you wish to delete.
4. Press the
button.
You will hear a confirmation tone.
5. Replace the handset.
Alternatively, any existing number stored
in memory or One-Touch memories can be
overwritten by entering a new number
under the same memory location. Simply
follow the instructions under the storing
numbers sections previously shown.
Store
M1
M2
M3
Store
Memory
Summary of Contents for T110
Page 9: ...www telstra com ...
