AUDIO CONFIGURATION (CONT.)
HX2 AUDIO CONFIGURATION
a.
Connect one cable to the SEND IN #1 XLR jack (E). Connect the other end of the cable to the
phone bus line output of your console.
b. Connect one cable to the RCV OUT #1 XLR jack (F). Connect the other end to the line input for the
channel designated for callers on your console.
c.
Connect one cable to the SEND IN #2 XLR jack (G). Connect the other end of the cable to the
phone bus line output of your console.
d. Connect one cable to the RCV OUT #2 XLR jack (H). Connect the other end to the line input for the
channel designated for callers on your console.
Hx2 TIP: If only one mix minus can be sent from your console, don’t fret! You can set up an
internal mix minus by setting the OPTIONS DIP #6 Switch on the rear panel to the ON position.
When this is done, the signal at SEND IN #1 will be sent to both callers and each callers’ audio will
be sent to the opposite hybrid for conferencing.
to phone bus line output
of your console
E
to line input for the
channel designated for
callers on your console
F
CONTINUE TO DIP SWITCH CONFIGURATION
The audio configurations for your Hx1 / Hx2 are complete. Continue to the
"DIP Switch Configuration" instructions.
G
to phone bus line output
of your console
H
to line input for the
channel designated for
callers on your console
