44
It is also possible to acknowledge notifications via SMS. The SMS-based acknowledgement
will acknowledge notifications initiated to the phone number of the SMS sender. In order to
acknowledge a notification via SMS, send the
STOP
message to the phone number of the
SIM card installed in the device. In order to stop all pending notifications, send the
STOP ALL
message to the phone number of the SIM card installed in the device.
Incoming call management
: in this section you can configure for each user what should the
device do when it receives a call from the given user. Independently of the selected option,
receiving a call from a user phone number also generates a service event, which you can configure
separately to control the output(s) or send notifications. Available options:
Accept call and request password
: the device accepts the call which it confirms by a short
signal tone and then the password should be entered in order to accept commands. The
superadmin and admin passwords are both accepted. The user needs to enter the valid
password using the phone’s keys as follows:
9device password#
(e.g.
91234#
). If the
valid password has been entered, the device confirms this by three short signal tones,
otherwise a long signal tone will be emitted. If the command is wrong (missing
or
#
), no
signal tone will be emitted. After the password has been accepted, the caller can use
commands as specified in the list of DTMF commands. The device will also identify the user’s
phone number by CLIP service, which makes it possible to perform further actions
automatically upon receiving the call. For this, an “
incoming call from user
” event should
be configured for the given phone number at the service events.
Accept call and don’t request password
: the device accepts the call which it confirms by
a short signal tone and then commands can be used as specified in the list of DTMF
commands, without the need of entering the password. The device will also identify the user’s
phone number by CLIP service, which makes it possible to perform further actions
automatically upon receiving the call. For this, an “
incoming call from user
” event should
be configured for the given phone number at the service events.
Reject call
: the device will reject calls received from the given user phone number, but will
identify the phone number by CLIP service for further actions, which are available by
configuring an “
incoming call from user
” event for the given phone number at the service
events. By rejecting the calls, the configured actions can be performed free of charge (except
if the given GSM service provider applies a charge for rejected calls as well).
E-mail notification recipients
(Pager4 PRO only
)
:
You can configure up to 4 e-mail addresses (
MAIL1
to
MAIL4
) to which the device will send
notification upon event occurrence, according to the event settings.
Name
: user/recipient name. The name entered in this section will be used upon selecting the
notification channels when configuring events. The name should not be longer than 50 characters,
and the following characters cannot be used: ^ ~ < > = | $ % " '.
E-mail address
: user/recipient e-mail address. You can configure 1 e-mail address per user.
