SL869-V3 EVK User Guide
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 17 of 26
Mod. 0810 2011-07 Rev.2
4.
Step-by-Step: First Time Running the SL869-V3
Evaluation Board
4.1.
Step-by-Step: First Time Connection
1.
Before connecting the evaluation board, ensure that the USB drivers are installed.
2.
Ensure that jumpers are installed on
J2
,
J6,
and
J7
.
3.
Ensure that there are no jumpers installed on
J3
and
J4
.
4.
Connect the provided Active Antenna to the SMA connector.
5.
As soon as the evaluation board is connected to the PC, it will be detected and installed.
Figure 4-1 USB installation, select "Continue Anyway" to proceed
6.
After the evaluation board has been installed, check the “Device Manager” window for
the evaluation board COM port number. This information is needed for use with the GPS
tools.
7.
Turn the switch vertically UP to turn On the EVK.
8.
Refer to Chapter 5 for using the EVK with software.
NOTE:
On some occasions, Windows will install a “Microsoft Serial BallPoint mouse after
connecting the USB. Uninstall the Microsoft Serial BallPoint mouse if Windows
mistakenly installs it.
