ME50
ME50
ME50
ME50----868 Demo Case
868 Demo Case
868 Demo Case
868 Demo Case User Guide
User Guide
User Guide
User Guide
1vv0300907 Rev.5 – 2012-10-15
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved.
Page 13 of 23
Mod. 0806 2011-07 Rev.2
4.2.
4.2.
4.2.
4.2.
DemoBoard Connection
DemoBoard Connection
DemoBoard Connection
DemoBoard Connection
In order to connect a demoboard :
1.
Connect the USB cable to the PC.
The Demoboard is supplied directly through the USB connection. In case of mobility is
needed, a +9V battery can be used. When battery is plugged, it has priority on the USB
power supply.
2.
Check that stand-by (STBY, SW1) and programming (PROG, SW3) switches are turned
OFF.
3.
Switch the DemoBoard ON (SW4). Check that the yellow LED LD2 lights on when
power supplying the DemoBoard.
OFF
ON
4.
Red LED LD3 blinks when the module is transmitting/receiving data frames, corresponds
to pin J1.
5.
Green LED LD4 lights on when the module is in normal mode (not stand-by mode),
corresponds to pin J2.
4.3.
4.3.
4.3.
4.3.
SR Manager Tool Installation
SR Manager Tool Installation
SR Manager Tool Installation
SR Manager Tool Installation
Refer to SR Tool user guide [3] for a detail description of SR tool installation
