Telit Wireless Solutions LE910-SKG, At Commands Reference Manual

Page: 216 / 273

LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 216 of 273
#SKTRST - Socket Parameters Reset
AT#SKTRST
Execution command resets the actual socket parameters in the NVM of the device
to the default ones.
The socket parameters to reset are:
-
User ID
- Password
- Packet Size
- Socket Inactivity Time-Out
- Data Sending Time-Out
- Socket Type
- Remote Port
- Remote Address
- TCP Connection Time-Out
AT#SKTRST=? Test command returns the OK result code.
Example AT#SKTRST
OK
socket parameters have been reset
#GPRS - GPRS Context Activation
AT#GPRS=
[<mode>]
Execution command deactivates/activates the EPS context, eventually proceeding
with the authentication with the parameters given with #PASSW and #USERID.
Parameter:
<mode> - EPS context activation mode
0 - EPS context deactivation request
1 - EPS context activation request
In the case that the EPS context has been activated, the result code
OK is preceded
by the intermediate result code:
+IP: <ip_address_obtained>
reporting the local IP address obtained from the network.
Note: if the cid 1was activated by +CGACT, Activation request/ Deactivation
request by #GPRS returns error.
AT#GPRS? Read command reports the current status of the EPS context, in the format:
#GPRS: <status>
where:
<status>
0 - EPS context deactivated