Telit Wireless Solutions GS2101M Series, Command Reference Manual

Page: 64 / 196

GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 64 2019-08-05
4.3 Profile Setting
GS node supports different operating modes with various settings pre-configured to work
with the system. A pre-defined set of variables can be stored in a profile. GS node currently
supports storing two different profiles (profile0 and profile1).
The following AT commands are sequentially executed for setting a profile:
– AT&V - To view the current profile
– AT&W - To write to profile settings
– ATZn - To load a profile
– AT&Y - To reboot with particular profile
– AT&F - To factory Reset
4.3.1 Get Profile
This command is used to get the information of current profiles (Profile 0 and Profile 1) and
their saved parameter values in ASCII format. The details of profile parameters are
described in
4.3.2 Save Profile, page 65 .
Command Syntax AT&V
Synchronous Response
Table 29, page 64 describes the synchronous responses and remarks for the Get profile
command.
Table 29 Get Profile Synchronous Responses
Responses Remarks
OK Success