GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0
193
2019-08-05
A.3.1 Exception Messages
The possible exception messages sent by the Adapter to the serial host are enumerated in
.
If the exception is due to one of the WLAN wd/SW Reset/Except, then the adapter send
memory dump information of its WLAN registers to the serial host starts with the message
\r\n---MEM-DUMP-START:\r\n
and end with the message
\n\r---MEM-DUMP-END:\r\n
.
Table 170 Exception Messages
No.
ASCII String
Meaning
1
\r\n\n\rAPP Reset-Wlan SW Reset\r\n\r\n
Adapter reset due to WLAN
processor software reset.
2
\n\rAPP Reset-APP SW Reset\r\n
Adapter reset due to app processor
software reset.
This can also be triggered when
AT+RESET command is issued and
in this case it is not considered an
asynchronous message.
3
\r\n\n\rAPP Reset-Wlan-Wd\r\n\r\n
Adapter reset due to WLAN
processor watchdog.
4
\r\n\n\rAPP Reset-App-Wd\r\n\r\n
Adapter reset due to app processor
watchdog.
5
\r\n\n\rAPP Reset-Wlan Except\r\n\r\n
Adapter reset due to WLAN
processor software abort or assert.
NOTE:
a.) Exception messages
a result of an undefined/unexpected behavior of the GS
module that can occur at any time.
b.)
All exception messages are sent after a module reset.
c.) After reset due to exception message, GS module comes back to the saved
profile state before reset.
