Telit Wireless Solutions GS2101M Series, Command Reference Manual

Page: 185 / 196

GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 185 2019-08-05
Example 1 - Not
associated state AT+WSTATUS
NOT ASSOCIATED
OK
Example 2 -
Associated state AT+WA=GainSpanDemo,,11
OK
AT+WSTATUS
MODE:0CHANNEL:11 SSID:”GainSpanDemo”
BSSID:98:fc:11:4a:b8:56SECURITY:NONE
OK
8.3.6 WLAN Statistics
This command is used to transmit or request statistics from WLAN. After providing the
statistics it resets all the counters. Every issuance of this command gives the statistics from
the previous issuance.
Command Syntax
AT+WLANSTATS
Command Note
Before issuing this command, make sure that you enable the “Ping and Trace Route”
option under the “Networking Services” tab while building the firmware in the SDK
Builder.
Usage
When the statistics are sent to the host, the clears them so that a new set of statistics are
collected for the next report.
This command returns the statistics counters in the following order separated. Some fields
have multiple values and for that failure and success counts are separated by a comma. Each
set is delimited by “:” character.
Table 166, page 185 describes GS node WLAN TX Statistic counters.
NOTE: This command is used for testing and debugging purpose only.
Table 166 GS Node WLAN TX Statistic Counters
WLAN Statistic Counters Description
itxs TX Success
itxto TX Timeout
itxf TX Failed
wep40 WEP-40 encrypted
wep104 WEP-104 encrypted
tkip TKIP encrypted