TELIKOU
SPK-200 Two-Channel Speaker Station
11
to the Intercom Line connector on another station. But Connect To switch set to
‘ONLINE’ position.
Solution 1: Reconnect by Online to Online.
Solution 2: Set Connect To switch of working channel to ‘INTERCOM LINE’ position.
(Especially SPK-200 connects to no TELIKOU main station)
Problem: Can not turn off the Mic function on all the beltpacks after
pressing RMK button
Cause 1: The connection among TELIKOU mains stations must go via Online
connector. If main stations are connected by Intercom Line connector, RMK
function will not work properly.
Solution 1: Check the connection among main stations. Please use Online
connector, and switch 'Connect To' to Online positon.
Cause 2: TELIKOU main stations are connected with Online connector. But
Connect To switch is set to ‘INTERCOM LINE’ position.
Solution 2: Check Connect To switch, set it to the proper position.
Cause 3: Some main stations are not TELIKOU. So these main stations do not
have Online connector. The connections among these main stations are with
Intercom Line connector.
Solution 3: Change to TELIKOU main station.
Problem: The volume of front panel speaker is too weak
Cause: When the front panel speaker is turned on, pressing Mic button will reduce
the speaker output level about 6dB and help minimize feedback
Solution: Turn off the Mic button after each speaking.
VI. Technical Specification
PRE-AMP:
Microphone impedance: Dynamic 200ohm
Gain form Mic to intercom line: +49dB
Bandwidth: 40Hz-8000Hz ± 2dB
POSTPOSITION-AMP:
Load impedance: 50-2000ohm
Output level: +17dBv
Distortion: <0.1% (1000Hz)
Gain from line to output: +31dB
BANDWIDTH:
200Hz-800Hz ± 2dB
SIDETONE:
