14
4
Configuring the unit via serial interface
In order to reconfigure or read trace values from the device via the serial interface, the correct
cable must be plugged into the proper connector.
Negative consequences on safety and device integrity may occur when
connecting the wrong cable to the unit and which is not listed in the Telic
accessory list.
1.
ENDURANCE PRIMARY
The device has to be opened by removing the cover lid and the cable (accessory part number
16210) has to be plugged into the 6-pin white connector as shown in Figure 8. Afterwards the
white button has to be pressed until the LEDs start blinking.
Figure 8: Connecting serial interface cable to the Endurance Primary
2.
Endurance Rechargeable
Open the small black lid on the top right side of the device; it needs to be pulled out.
Figure 9: Where to plug the configuration cable inside
