CAUTION
•Do NOT set SW1-2 and SW1-3 ON concurrently.
•Do NOT set SW1-1 ON concurrently with selecting 1/30 (1/30s Non-interlace
Mode) video output mode.
6. CONNECTION
(1) CS8531 connector pin configuration
Connector (CS8531 CCU side)
DC/SYNC connector; HR10A-10R-12PB, Hirose Elec. Co.
Connector (Cable side)
DC/SYNC connector; HR10A-10R-12S, Hirose Elec. Co.
Pin number Signal name Pin number Signal name
1 GND 7 VD/VS SYNCH IN
/OUT
2 +12V 8 GND
3 VIDEO.GND 9 VIDEO.2
OUT
4 VIDEO.1
OUT 10 GND
5 HD/VD.GND 11 TRIG
IN
6
HD IN
/OUT
12
GND
Caution: When DC IN/SYNC (12-pin connector) is in use for video output, NEVER use
either of BNC connectors for the same use.(These are in two places.) If both
type of connectors are used at the same time, that will cause double termination,
Thus proper video output will not be gained.
External Sync. Signal is IN/OUT selectable by inner switch inside the camera control
unit.
(2) HD, VD
Input / Output: IN/OUT selectable (With an inner SW, Initial factory-setting: IN)
IN: For inputting HD, VD into CS8531. (Initial factory shipped setting)
OUT: For outputting HD, VD from CS8531.
7
