TROUBLESHOOTING
Reread the sections of this manual to make sure you
have completed system set-up properly
If you are unable to solve the problem, contact the
dealer from whom you purchased the system for as-
sistance.
-31-
PROBLEM
SOLUTION
DISTORTION - System’s audio quality seems
distorted at medium to high input levels.
R e d u c e m i c r o p h o n e g a i n
b y a d j u s t i n g
microphone gain control.
HISS - System seems to produce a “hiss” which is
undesirable.
Check the gain setting on all beltpacks and the
base. They may be too low.
LOW OUTPUT - System produces a low output
level.
Check the gain setting on both the beltpacks and
the base. They may be too low.
FEEDBACK - Moving around area of use
produces “squeal” or “howl” in various locations
using ext. speakers.
Reduce the gain settings on both the beltpacks and
the base. They may be too high.
DROPOUTS - When moving around the area of
use there seems to be locations where the signal
“swooshes” or completely disappears.
Make sure both antennas on the base are
connected and follow the location suggestions.
Change the location of the base unit and antennas
or avoid the bad areas with the remote beltpacks.
INTERFERENCE - System picks up signals
other than wireless Intercoms.
Make sure the Telex beltpack is turned on - this
will usually eliminate the interfering signal. If not
using a beltpack, make sure the transmit mode
switch at the base is in the off position.
If problems persist with the beltpack on, you will
probably need to change frequency channels.
Make sure the base channel switch matches the
beltpack.
NO AUDIO from BASE or BELTPACK headsets.
Check Transmitter switch on base, use CONT or
REMOTE position. Check push-to-talk function -
is the switch ON. Make sure beltpack batteries are
OK.
