Revision A
Page 3 of 10
6/24/09
QUICK SET UP AND OPERATION
Synching Up The Transmitter and Base
The synch operation only needs to be performed
the first time a system is used, or a new bodypack is used with a base previously synched to
another bodypack. Do not perform the synch operation multiple times; it only needs to
be done one time when a new bodypack is used with a new base.
1) Make certain the Master/Slave switch on the side of the transmitter is in the
Master (M) position.
2) Turn the transmitter power switch to ON and place the transmitter in the
recharge cradle of the base. The transmitter goes in the base with the
beltclip facing out.
3) The recharge LED will light (Green if fully charged, Red if charging). Leave
the transmitter in the cradle for 4 hours for a full charge.
3) Press the In-Use button on the transmitter and hold for 5 seconds (or until
you hear beeps if the beep is enabled to confirm synch), then release the
button.
4) The transmitter and base are now synched and will continue to be until
another transmitter is linked to that base.
Normal Operation
1) With the transmitter synched up, remove it from the cradle, plug in the lapel
microphone (if used) and place the transmitter on your belt.
2) To start the recording, press the In-Use button and the In-Use LED will light a
constant green and you will hear a short beep or feel a short vibration.
3) To end recording, press the In-Use button and the In-Use LED will turn off
and you will hear a short beep or feel a vibration.
4) At the end of your shift turn the transmitter off and replace it in the charging
cradle.
Two Transmitter Operation on One Base
1) If one of the transmitters to be used with the base is already set to Master
and synched to the base, skip to step 5.
2) Set the Master/Slave switch on one of the transmitters to Master (M), put the
BEEP switch to BEEP and turn the power switch to ON. Then place the
transmitter in the recharge cradle of the base.
3) Press the In-Use button on the transmitter and hold for 5 seconds or until you
hear a beep, then release the button.
4) The Master transmitter is now synched to the base.
5) On the second transmitter, place the Master/Slave switch in the Slave (S)
position.
6) Turn on the power and place the BEEP switch to BEEP and place the
transmitter in the recharge cradle.
7) Press and hold the In-Use button for 5 seconds or until you hear a beep.
8) Both transmitters are now ready for use with this base. The master
transmitter will control the video trigger relay and either will be able to trigger
the Emergency relay.
Low Battery Warning
1) If the transmitter Low BATT indicator (red) starts flashing or you hear warning
beeps (or vibrations), return the transmitter to its cradle on the receiver to
fully charge the transmitter.
2) The Charge LED indicator will light constant green when the unit is fully
charged.
