TELEX Ev HTV Owners manual
Page 2
If the interference is not severe, suitable operation can sometimes be made
possible by adjusting the squelch control until the light goes off. (Transmitter off)
If the light cannot be made to go off by adjusting the squelch control, then the
frequency should be changed.
Set the receiver audio output control to its midpoint (50 % of rotation).
Open the transmitter battery door and install a fresh 9 volt alkaline battery. Place
the transmitter in the position desired and turn on the power switch. The Green
battery light should flash once and go off. The carrier light at the receiver should
now be on. You are now ready to use the microphone. Place the transmitter mute
switch in the on position (up). Talk in your normal tone and volume. If the Red
light on the transmitter comes on or continues to flash as you speak, turn down the
microphone gain control until the Red light is off or only flash’s on occasion. If
the audio to the mixer or amplifier sounds distorted or clipped, try reducing the
input volume of the mixer or amplifier, or turn the volume down on the receiver.
FCC REGULATIONS
The Telex/Ev Model HTV is Type Accepted under United States Federal
Communications Part 74. Licensing of Telex equipment is the users
responsibility and licensibility depends upon the users classification and
the frequency selected. Telex strongly urges the user to contact the appropriate
telecommunications authority before ordering frequencies other than factory
preset frequencies.
CAUTION:
Changes or modifications made by the user could void the users authority to
use the equipment.