6
5.
Replace the
case top
on the unit.
6.
Adjust the
hanger switch
so the button is off the surface of the case top without the handset.
When the handset is replaced the switch button should be active. This is done by loosening the mounting screws in the hanger and
moving the switch in or out until you can hear the switch open and close as the handset moves on and off the hanger.
7.
Place the
handset
on the hanger.
8.
Plug the
handset
into the connector marked HANDSET on the back of the unit.
Handset Mounting Holes
Older
IP-1616/C-6200
units require handset
mounting holes to be drilled.
IP-1616/C-6200 Drilling Instructions
To
drill handset mounting holes into the IP-1616/C-6200 case top
, do the following:
1.
Remove the
screws
holding the case top to the unit and position the case top to allow the right side of the case to be drilled.
2.
Go to
http://www.telex.com/US/dispatch/downloads
, to download the drill template needed from the Drawings section.
3.
Print the drill
template
and verify it is to scale.
NOTE:
Before drilling, take measures to insure no drill chips and/or debris get into the electronics of the unit.
4.
Overlay the
template
on the side of the unit and
punch center pins
for each hole to be drilled.
5.
Drill the
holes
. (3X .313” Dia., 2X .144” Dia.)
6.
Proceed with
Step 4
on page 2.
