TeleWell TW-EA510 v2, User Manual

Page: 18 / 92

16
3.2 Factory Default Settings
Before configuring the router, you need to know the following default settings.
Web Interface:
Username: admin
Password: admin
LAN Device IP Settings:
IP Address: 192.168.0.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site:
RFC 1483 LLC Bridge
Auto support for VPI=0,14 and VCI=24,33,50,100 if auto-scan fails!
During the 1
st
connection IP – traffic may take 2-4 minutes after boot.
Device will auto-scan correct parameters for ISP line on this period.
NAT enabled
DHCP Server:
DHCP server is enabled.
Start IP Address: 192.168.0.100
IP pool counts: 100
3.3 Username and Password
The default username and password are “ admin ” and “ admin ” respectively.
To reset the router or to restore it to factory default settings press the
Reset button using the end of paper clip or other small pointed object.
1. To perform Failure recovery for a dead router:
Simply hold the Reset button when powering on the router and
download an application if necessary.
2. To perform recovery in case of a misplaced Password:
Hold the Reset button until the LEDs all turn Off, turn On and then turn
Off. The router performs configuration factory reset and the router
reboots. You can then access the router from the web GUI.
Attention