Teletype 43K001/AAA, Repair Manual, Page: 39 / 82

To reassemble the cable:
(a) Insert new cable connector into circuit
card holes and press into place. Hold cable
connector in place and resolder.
(b) Fasten cable to card using locally furnished
cable tie.
(c) Reassemble the keyswitches and keytops
removed in Cable (KSR), (a) and (b), Page
3-6.
(d) Replace circuit card cover removed in
Cable (KSR), (d) Page 3-6.
(e) Replace rear plate.
(f) Replace circuit card shield.
Cable (RO)
To remove the cable:
(a) Remove the interlock keyswitch (Fig. 24)
(refer to Keyswitches, Page 3-5).
�
INTERLOCK
KEY SWITCH
•
�
Fig. 24-Interlock Switch
(b) Remove solder from around connector
pins of cable to be removed (Fig. 25 ).
6
• 6
•
•
6
•
6 •
6
•
6
6
•
•
•
•
• •
..____SOLDER
REMOVED
Fig. 25-connector Pins
Warning: Use a grounded, low-wattage solder­
ing iron (avoid prolonged contact with pins)
along with a desoldering tool to prevent damage
to card circuits and components.
MANUAL 525, 3-7
(c) Cut the cable tie securing the cable to the
circuit card.
(d) Remove the screw securing the right rear
corner of the circuit card to the channel
(Fig. 26).
��
Fig. 26-8crew Removal
(e) Grasp the cable connector using thumb
and index finger (Fig. 27).
(f) Exert upward force until cable connector
releases.
(g) While biasing the right rear corner of the
circuit card downward, slide the cable to
the right until it clears the circuit card. Remove
the cable.
(Top View)
Fig. 27-cable Connector Removal