Switch from Station/Bridge Mode to Access Point
Mode
To upgrade the Access Point from
Station /Bridge
mode to
Access Point
mode, please go along with
the steps below:
•
During the upgrade, all LEDs on the equipment
flash. Note that the sudden loss of power may
cause serious problems at the moment. Please
keep regular power supply during the process.
a)
Use crossover LAN cable to connect the Access
Point with PC.
b)
Connect the power adapter to the power jack on
the Access Point.
c)
Press the
Set to Default
button at the edge of
the Access Point.
d)
Set the
IP address
of PC, for example, to
192.168.1.10, and
Subnet mask
to
255.255.255.0.
e)
Unzip
wlan_ap_ug_xxxxx.zip
to the directory
c:\
, and then you can see the
wlan_ap
directory.
f)
Execute
sta2ap.bat
, which is in the directory
wlan_ap/upgrade
. The Dos console mode is
shown as below:
g)
Figure 8
The screen demonstrates the operation of this
procedure. If there is no inquiry, press any key to
continue.
a)
After pressing a key, you will see the screen
shows as below. This step writes firmware base
image and Web page image Access Point. After
the action of writing is complete, the screen will
inform the message-
Done
. Press any key to
leave.
Figure 9
*
If any inaccuracy appears, please check
Ethernet RJ45 cable connection and IP address
settings of PC.
*
After the procedure of upgrading completes,
the default IP of the Access Point is
192.168.1.90.
2503501300
