7
User manual
The equipment could be started by turning the power switch ON, located beside power
connector. After the turn on, the POWER LED starts to light in case of faultless function. After
the start the LCD informs the user about the main state of the equipment:
At first by the boot procedure in the 1
st
line with the ‘Teletechnika Ltd. - MPEG4 HD
ENCODER’ label. In the 2
nd
line are the ‘Initializing .......’ label. Please wait by the boot section
about 15-20 seconds. By successful start an ‘OK’ word will appear after the points. If we have
some problem a ‘REBOOT!’ word and the equipment reboots until the successfully boot occurs.
Then, the previously described information displayed on the display.
Settings
The settings of the equipment only could be done via the MGMT connector. If there is
only a cable between the equipment end the computer it must be a crosslink type, otherwise e.g.
with a switch or router, the type of the used cable is not important.
To operate and reach the Encoder with our PC it has to be set into the same IP address
range as the equipment. The factory IP address of the equipment is on the 10th page of LCD. The
factory IP address begins with ‘192.168.1.’ with 255.255.255.0 mask.
