TM109902 (5/03)
3-1
USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE
RESTRICTION ON THE TITLE PAGE OF THIS DOCUMENT
.
C
O M M A N D
S
Y S T E M S
D
I V I S I O N
3.1 GENERAL
This chapter contains applicable maintenance practices related to the RT-1601 Receiver –
Transmitter. Included in this section are inspection, adjustments and troubleshooting test point
waveforms, cleaning and repair information; and disassembly/assembly instructions.
3.2 VISUAL
INSPECTION
A routine visual inspection should be performed any time the receiver transmitter is removed from
the aircraft. The following areas are of prime importance.
A. Chassis
Inspect the chassis for loose or missing hardware, deformation, damaged fasteners, or damaged
connectors.
B. Connectors
Inspect the connector bodies for broken parts; check the insulation for cracks; and check the
contacts for damage, misalignment, corrosion or bad plating. Check for broken, loose, or poorly
soldered connections to the terminals of the connectors. Inspect connector hoods and cable
clamps for pinched wires.
C. Terminal Connections
Inspect for corrosion and loose connections.
D. Wiring
Inspect the wiring of the chassis and subassemblies for any signs of physical damage or
charring.
E. Capacitors
Inspect capacitors for case or body damage and for loose, broken or corroded terminal
connections.
F. Resistors and Diodes
Inspect for blistered, charred, or cracked bodies; also check for loose, broken, or corroded
terminal connections.
The document reference is online, please check the correspondence between the online documentation and the printed version.
