“Flash” hook function - Flash # 5 & # 13
The Flash function is used to access PBX features or Telco line features such as Call
Waiting. The Flash function is a 600mS timed line break. If the Flash function will be
used often, store the feature into memory located for easy access as follows:
1. Press Speakerphone ON/OFF key, then press the “Store” key.
2. Press the “Flash” Key -
# 5
&
# 13
.
3. Press the memory location wherein the “Flash” is to be stored.
4. Press Speaker key to end this programming phase.
Storing a Number Into Memory Keys # 10 or TouchLite key # 17
Each location can store up to 24 digits in tone mode.
Note: A “Pause” or “Flash” programmed into memory counts as one digit when
storing a number.
1. Press the Speakerphone ON/OFF key to activate telephone -
# 15
.
2. Press the STORE Key -
# 4
.
3. Enter the number to be stored using the numeric dial pad.
4. Press the desired memory location wherein the number is to be stored.
5. If additional numbers are to be stored, repeat steps 3 thru 5.
6. Press Speaker key to end this programming phase.
Some of these programming keys are located under the faceplate and overlay, begin by
lifting up faceplate and overlay, by either a paperclip or sharp pointer.
Programming...
7
8
Programming Flash Timing & Pause Timing
Flash timing options are 100mS thru 1000mS, programmable in 100mS increments. The
default Flash timing is 600mS.
Pause timing options are 1.0 sec. thru 5.0 seconds. The default Pause timing is 3.6 sec.
1. Press the Speakerphone ON/OFF key to activate the telephone -
# 15
.
2. Press the “Store” key once -
# 4
.
3a. Program “Flash” by pressing “1” for 100mS, “2” for 200mS, etc....
# 5 & 13
3b. When programming “Pause” press “1” for 1.0 sec., “2” for 2.0 sec., etc...
# 11
.
4. Press “Store” key again.
5. Press “Flash” key again. The long “beep” means that the setting was successful.
6. Exit programming by pressing Speaker key again.
Note:
Use 3a. when programming “Flash” / Use 3b. when programming “Pause”
