DTR4000CA Factory Default Satellite Information
22KHz
Depending on the use’s antenna switch box or LNB,
you can supply either 22KHz by setting “On” or off
by setting “off”
Tone Burst
Depending on the user’s antenna switch box, you can
pick up either A by setting “SA”, B by setting “SB”,
or “Off”.
DiSEqC
If you have DiSEqC box(es), you can choose port one
to four by selecting port number one to four. Or if you
do not have DiSEqC box, choose “off”
* This setting should be done for all the LNBs that you want to connect to by
changing the LNB name.
Channel Search
Channel Search helps you catch the channel information of each transponder.
In Installation menu, select Channel Search menu. Then the Channel Search
screen pops up
LNB
From LNBs that you set up in LNB Setup menu, select
one LNB.
Down Frequency(MHz)
Enter the transponder frequency of the satellite that you
choose by setting LNB parameters.
Symbol Rate(KS/s)
Enter the symbol rate of the above-mentioned
transponder or set up “Auto” if you do not know the
symbol rate. In latter case, it will take time.
Polarization
Choose the Polarization of the above-mentioned
transponder. Select “VER” if the polarization is vertical,
or “HOR” if it is horizontal. if you do not know the
Polarization, select “Auto”. In latter case, it will take
time.
FEC(Forward Error
Correction)
Choose FEC of the above-mentioned transponder. – 1/2,
2/3, 3/4, 5/6, 7/8. If you do not know the value, choose
“Auto”.
Manual Search
If the channel information that you are looking for is not
included in the SI Information that comes from the
satellite, user can manually enter those information.
In Auto mode, you can automatically search channel
information that comes from satellite. If you want to
manually enter TV channel, select “TV”. Then you
should enter those PIDs of Video, Audio, and PCR. In
case of Radio, enter the PIDs of Audio and PCR.
