Telegärtner DoorLine TM4, Operating And Assembly Instructions Manual

Page: 25 / 52

Configuration
5
DoorLine TM4 25 / 52
The remaining call numbers are deleted in the same manner. The following
commands must be used to do this:
Deletion of call number 2 for bell pushbutton 1
Deletion of call number 1 for bell pushbutton 2
Deletion of call number 2 for bell pushbutton 2
Deletion of call number 1 for bell pushbutton 3
Deletion of call number 2 for bell pushbutton 3
Deletion of call number 1 for bell pushbutton 4
Deletion of call number 2 for bell pushbutton 4
5.11 Enabling door opener function
For security reasons to prevent unauthorised opening, the door cannot be
opened if the connection was set up from the telephone to the door intercom.
This function can be deactivated if desired.
1. Enter the configuration mode (see chapter Entry to config-
uration mode [
}
19])
2. Actuate the hashtag button and star button on the tele-
phone
3. Enter configuration command "04" at the telephone
As confirmation, you will hear a neutral acknowledgement
tone
4. Enter digit 1 to enable the door opener function or
digit 0 to block the door opener function
Finally, you will hear the positive acknowledgement tone