Nr. Function
1
Mode keys:
TRC 400: TV · SAT · DVD · AUX
TRC 800: TV · VCR · DVD · SAT · AUX1 · CBL · AMP · AUX2
2
Power: On/Off
3
Digital keypad 0-9
4
TV/Radio / -/--: Toggle between TV and Radio (SAT mode) or access to 2 digit channels
(TV mode and some equipment only).
5
AV: Access to external A/V input
6
EPG: Electronic Program Guide (if available on your equipment)
7
Menu: open menu of the selected appliance
8
EXIT: Exit Menu
9
Vol+/Vol–: Volume up/down
10
CH+/CH–: Channel up/down
11
OK: to confirm a selection
12
Direction keys: to navigate in the On Screen Menu
13
Red LED indicator: The indicator light flashes when the remote is operating
or lights continuously while you are programming the remote.
14
Info: Displays program channel information.
15
Mute: Turns the Volume on/off.
16
Back: Toggle between the 2 last selected channels of the selected equipment
(when available on the equipment).
17
왗왗
Rewind
왘
Play
왘왘
Fast Forward
쎲
Record
왎
Stop
왎왎
Pause
18
Colours keys: Fast teletext function or special function depending of the equipment
19
S (Setup): Allows you to program your remote before the first use.
20
: Teletext On.
: Teletext Hold.
: Teletext Mix.
: Teletext Off.
21
Learn: Used for the learning codes procedure (key copying) (see page 15)
(only TRC 800, item no. 55414)
Inserting the batteries
Two CR2032 batteries are included in delivery. In order to use the remote control, open the
battery compartment and remove the protective foil. If the batteries need changing always use
two NEW CR2032 batteries.
1. Open the cover on the back of the remote control.
2. Check the +/– polarity on the batteries and inside the compartment.
3. Insert the batteries.
4. Close the cover.
Introduction
The 4in1 (item no. 55413) • 8in1 (item no. 55414) Universal Remote Control is designed to
control up to 4 or 8 devices.
The Universal Remote Control contains a library of codes that are pre-programmed into the remote
control. This library covers nearly all the audio video products on the market today. The SAT, DVD,
VCR, CBL, AMP and AUX (1 and 2) mode keys can be programmed to control a device other than
the one indicated on the key. It is therefore possible, for example, to allocate DVD mode to the
SAT key. You must enter the code corresponding to the manufacturer and the device by using one
of the methods indicated in this manual.
13
