Telefunken TF-?SRP3480, Instruction Manual

Page: 4 / 17

4
Instruction manual
Radio operation
• Press the ON/STANDBY button to switch
the unit on.
• Press the FUNCTION button repeatedly
until the display shows FM.
• To improve radio reception, adjust the unit
position. To further enhance reception, extend
the telescopic antenna found at the rear of the
unit.
• After tuning into a desired station, use FM
MODE button to select MONO/STEREO mode.
In cases of poor reception we recommend to
use the MONO mode for better sound clarity.
Automatic scan and store
• Press and hold FM MODE, the unit will
automatically scan all stations and store the
first 30 found stations into the memory presets.
Manual frequency adjustment
• Press and quickly release the TUNE+ or
TUNE- buttons to manually adjust the radio
frequency one step at a time.
• When the desired station is found, it can
be saved into one of the MEMORY positions.
See “Radio memory” section for further
details.
Automatic frequency adjustment
• Press and hold the TUNE+ or TUNE-
buttons to automatically seek the next available
radio frequency.
• When the desired station is found, it can
be saved into one of the MEMORY positions.
See “Radio memory” section for further
details.
Radio memory
• After tuning into a desired station, it can
be stored into one of the 30 available memory
positions.
• Short press the MEM./PROG. button to go
to memory setting mode.
• Press and release the MEM UP button to
choose the desired memory storage position
4
you would like to store into (up to 30).
• Short press MEM./PROG. again to confirm
selection. The display will stop flashing.
Recalling a saved memory station
• Press MEM UP button to find a saved
memory position.
• To erase a saved radio station, simply
replace it with a new station in the same
memory position.
Compact disc operations
Insertion and removal of discs
• When opening the CD-door, always
ensure the disc is not in motion (not spinning)
when you open the CD-door. Always press
STOP button to stop the disc spinning first.
• Place a CD into the compartment with the
label-side (printed side of disc) facing upwards.
Press down in the center part of disc until the
disc “locks” onto the center spindle.
• When the CD has been placed onto the
center spindle, gently lower the CD-door
downwards until it locks shut. The CD is now
ready to be played.
• To remove a disc, follow the same
procedure as described above, except to
remove the CD instead of inserting it into the
compartment, by placing one finger at the
middle of disc (center spindle) & the other at
the edge of the disc & gently pulling upwards.
Please make sure to always fold down
the handle before opening the CD door.
• Press CD button to enter CD mode.
• Put a disc into the CD compartment and
close the CD door.
• The display will indicate “READ” for a few
seconds and then start to play the first track.
• The display will indicate the current track
number and playback time.
General operation
• Set FUNCTION switch to CD position.
• Put a disc into the CD compartment and