Telefunken L22F137D2, Instruction Manual, Page: 27 / 55

English - 26 -
Installing the Batteries to the Remote
1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
+
+
- -
Connect Power & Antenna/Cable
IMPORTANT : The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
SPDIF
VGA
Aerial or Cable
Switching On/Off
To Switch the TV On
• Connect the power cord to the 220-240V AC, 50
Hz socket.
• Switch the “ ” button on the rear left hand side
to position “|” so the TV will switch to standby mode.
Then the standby LED lights up.
To switch on the TV from standby mode either:
a. Press the “ ” button, P+/P- or a numeric button on
the remote control.
b. Press the middle of the “ ” button on the TV.
By either method the TV will switch on.
Switching the TV Off
• Press the “ ” button on the remote control or press
the “
” button, so the TV will switch to standby
mode.
Switch the “ ” button to position 2 as illustrated,
so the TV will switch OFF.
To turn off the TV completely, remove the power
cord plug from the mains power socket.
Note
: When the TV is switched to standby mode, standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED
can also blink when you switch on the TV from standby
mode.
First Time Installation
When turned on for the first time, the “language
selection” menu appears. The message “ Welcome
please select your language! ” is displayed in all
language options listed alphabetically.
Press the “ ” or “ ” button to highlight the
required language, press OK button to select. “First
Time Installation” appears. Use “ ” or “ ” button to
set the required country, and press “ ” button to
select Search Type (optional).
Use “ ” or “ ” to set the desired search type. Available
search types are Digital and analog, digital only and
analog only.
When set, press “
” to select Teletext Language.
Use “ ” or “ ” to select the desired Teletext Language.
Next, select
Scan Encrypted
and set as
Yes
if you
want to scan coded stations.
Press
OK
button on the remote control to continue
and the following message will be displayed on the
screen.