- 7 -
the installation of the switch.
Checking if there was suitable power supply for the switch.
Please select the correct position for the switch. Install switch on DIN-RAIL
as following steps:
Insert the upper part of the DIN rail into the slot on the upper part of the
DIN rail connection base with the circlip. Slightly push down on the top panel of
the switch and rotate the device as below picture.
Insert DIN-rail into DIN-Rail slot and confirm the switch reliable installed
on the DIN-rail.
3.3.2. Cable connection
After the switch is correctly installed , you can install and connect the
cables,which mainly include cable connections of the following interfaces.
Operation port
The terminal equipment interfaces are Gigabit and 100M Ethernet RJ45
interfaces and gigabit optical ports, so it can be connected to terminal
equipment or network equipment by using direct network cables and optical
fiber cables
Power connect
The switch use power according to the instructions on the product label.
When all other cables are connected, you can connect to the power supply.
3.3.3. Fiber connection
This product has two full-duplex 1000Base-X single mode / multi mode
fiber interface and use hot-pluggable SFP during the optical interface using LC
connectors. Optical interface to be used in pairs (TX and RX as a pair), TX port
is the optical transmitting end,which is connected to the optical receiving end
RX of the another remote switch optical interface; RX ports is the optical
receiving end which is connected to the optical transmitting end TX of the same
remote switch optical interface. Two remote switches optical interfaces can be
connected by using 2 redundant 1000Base-X optical fiber interfaces at the
same time.
SFP optical module shown in the figure :
TELE2210G-2GF-8GT Full Gigabit Din-rail mount Industrial Ethernet Switch
www.telefly.cn
